Resolution: 1920* 1080P / Power: 220 ma/H
Memory: 128g / Frame number floating 30fps
1. The boot, Push the power switch on the machine to turn on, long press the “A” button of the remote control until the blue, red light comes on at the same time, release the “A” button, and the red light will come on after 1 second, and the camera will be in standby mode.
2. The video, long press B key, red light flashes twice, red light goes off, enter the video state. The red light of the short B key is long, and the video saved successfully.
Short press A key, red and blue lights flash three times at the same time, the lights off.
Record 5 minutes of a section automatically save a document, card full will automatically cycle video.
3. Take pictures, after starting up, the red light is always on. Press the c button to flash the red and blue light to take a photo at the same time. Press this operation to take a cyclic photo.
4. Motion detection, after starting up, the red light is always on. Short press D, the red and blue lights flash out at the same time, enter the motion detection video. Short press D, the red light will stay on to save the video successfully. Press A again to turn it off.
II Recording while illing:
1. Turn on the power switch of the machine before charging through USB. When charging, the red light keeps flashing and the blue light flashes. When full, the blue light stops flashing.
2.When charging press B button, the red-light flashes three times, and the red light goes off to enter the recording state. Press the B button again and the red light will be on. Save the video successfully Press A key Can shut down.
3. Taking photos, motion detection, operation when charging, blue light flashing. Other operations are consistent with the basic operations.
Create a TXT document in memory, name it “time rest,” content such as :2014.05 2816:22:00 modify the number to modify the time, and then save.
Note: the time needs to be revised after the machine is completely cut off. When the remote control does not work, pay attention to replacing the battery of the remote control, you can manipulate the machine keys to verify whether there is a problem with the remote control.
For example: 2015.05.12 09:07:00y
It means: 9:07 am, May 12, 2015. The time is shown on the screen.
Y: indicates that the time is displayed on the screen image
N: indicates that the time is not displayed on the screen image