3 Axis Brushless Gimbal Stabilizer Camera Mount Holder Storm32 Plug and Play for DJI Phantom 2 F450 Walkera X350 for GoPro YI 4K
Name: lightweight brushless gimbal
Assembled and debugged, plug and play
Material: Aluminium alloy
Motor: 2 * 2206/100T brushless motor + 1 * 2805/100T brushless motor
Strap: for GoPro Hero 3/4, Hawkeye Firefly 7S / 8S and similar size camera( not included)
Driver board: STORM32BGC
Firmware version: o323bgc-release-v070
Hardware version: V130
Battery plug type: JST
Input voltage: 11.1-16.8V / 3-4S LiPo battery
Working current: 350mA
Yaw: -90~ +90
Weight: about 181g
IR LED Interface
Spektrum satellite port
7CH PWM/SUM-PPM input/output
Each axis could connect analog joystick
With I2C port, could use external 6050 to replace onboard sensor
3 x AUX port
Package size: 13 x 13 x 13cm
Compatible drone: for DJI phantom 1/2 F550 CX-20 Walkera X350 or other DIY drones.
How to install:
1. Remove the damping balls, open the top cover of the mounting plate.
2. Install the top cover of the mounting plate to the bottom of the drone.
3. Install the damping balls.
4. Install your camera, and fasten it with straps.
5. Position the camera and then power it on.
Do not power on the gimbal before mounting the camera, or the gimbal will shaking greatly.
Stabilize the gimbal for about 20 seconds after power-on (do not shake the gimbal, keep the gimbal hangs, leave the ground), after hearing a sound, you can use it normally.
The camera strap must be bundled securely.
The fixing strap and mounting plate opening are round. If your sports camera lens is square, you can fix the camera in other forms.
(The steady red light is the power indicator. The yellow light lighting after flashing, it is detected that the gyroscope is working normally.)
Question 1: Why the gimbal shaking so much after power supply?
1:When receive the gimbal, first install the camera, then supply the power, otherwise the gimbal will shake if not install the camera.
2:The gimbal can only load the camera, because the gimbal has requirement to the weight, if equipped with a light camera , it will also shake, because it is too light.
3: If the cable bind the gimbal , the motor will also shake, pls let the cable far away from the gimbal.
Question 2: The Gimbal cannot work after supply the power?
1: pls insert the sensor again, the sensor may be loose during transportation. Just insert once again.
Question 3: Why the gimbal board burned?
1: the current is too large, the breakdown of the IC module,pls use battery of low Amperage。
Question 4: What voltages can be used of the gimbal?
1:we proposed using 11.1-16.8V ( 3-4S LiPo battery )
1 * 3 Axis gimbal
1 * Camera fix strap
1 * Receiver pin cable
1 * JST cable
1 * Screw set
1 * Manual
Notes by OK RC:
3 Axis gimbal kit only, others not included.
There may be some deviation due to manual measurement.
The colors deviation might differ due to different monitor settings, please kindly understand.
“OK RC” has only one store, no branch, other pictures and descriptions of the same store as us , are competitors copying us, we are more professional than them !
We provide you with the best product and service. If you have any problem, please let us know, and we will solve the problem ASAP.
Thank you so much, nice day !