swing Gate Opener 12V Electric lock
Popular Electromagnetic Lock for Swing Gates and Doors, is designed to provide extra security and stability to your gate opener system. They are suitable for various types of gates. It can work with swing gate opener to enforce the lock,especially for heavy windy days。
Automatic Electric Gate Lock foranimal enclosures or high wind areas. Swing Gate Operator Opener system 12VDC or 24VDC
Installing The Gate Lock
NOTE: The Automatic Gate Lock can be installed on single and dual gate systems. Use the
app instructions for the system you have – SINGLE GATE (below) or DUAL GATES (below)
Single Gate Installation
Disconnect gate opener by removing hairpin clip and clevis pin from the gate bracket end of
the open, Disconnecting the opener will allow the gate to swing freely during installation of
the gate lock.
Step 1: With the gate in the closed position, determine the best location for the lock and the
lock receiver. The lock and receiver must be level and aligned with the opener. Also, the lock
should have a solid surface or cross member to provide stability.
Step 2: Clamp receiver and lock together (with receiver pin hole and lock slot aligned) to the
gates, mark their positions to drill receiver bolts (lustration B and C, page 3). The receiver
must be mounted with carriage bolts, not U-bolts, to allow lock to seat properly.
Step 3: Recheck the lock’s position and alignment, then mark its position for drilling holes. Drill
the hole gate supports through the slots in the lock bracket. U-bolts and saddles can be
used to mount on chain link gate supports. Secure the lock to the gate. Install clevis pin
and locking cap by placing clevis pin through slots in lock receiver and hammering the
clevis pin into the locking plug, secure the lock bracket and check the alignment again.
One set includes:
1 lock with 6 metre cable
1 lock receiver
1 Clevins Pin
1 plug pin
2 lock key(Manual release )