Lintratek LTE 4G Repeater 700Mhz Band 13 Signal Booster
65dB KW16L-B13
SIUT FOR USA, Canada, …
Product advantages
1. Mini Size but high gain 65dBi
2. Intelligent LCD display
3. Full kit with antennas and cable
4. Cover about 500 sqm without barrier
5. Easy to install and work
6. Work for 4g 700Mhz
How does the booster work?
1.The outdoor antenna is to receive good signal from the base station,
so, it shall be at some higher position to receive better signal.
2.Then the signal would be passed to the booster by cable.
3.Our booster would amplify the signal and pass it to indoor antenna.
4.Lastly, indoor antenna would transit good signal at your house.
How to install
Find a position where you could receive great signal, mostly a higher position, like a rooftop. Install outdoor antenna at it and make it toward the base station.
the outdoor antenna shall receive good signal, otherwise the repeater could not work.
Connect outdoor antenna to booster at BTS connector with the cable.
Connect indoor antenna to booster at MS connector. And it would be better to install it at a height of 2 meters.
The two antennas shall be totally separated by a brick wall with a distance of at least 10 meters. Otherwise, the signal would intervene to each other, showing full of signal on display, but the booster doesn’t work properly.
Plug in power supply and done!
Common problem
Question: no signal on the display and phone
Solution: adjust outdoor antenna, put it at a higher position and make sure it can receive good signal from base station. Or please check the frequency of your antenna if you buy only booster from us. If the frequency doesn’t match the booster’s, it could not work either.
Question: the display is blinking, and signal light isn’t on.
Solution: Also adjust outdoor antenna as above because blinking means receiving signal is not stable. Adjust the position and direction of outdoor antenna until it stops working.
Question: the signal is at maximum on booster but the signal on the phone does not improve at all
Solution: It is what we call the “self-oscillation phenomenon”. You need to increase the distance of indoor antenna and outdoor antenna and separate them with a brick wall. Make sure there is no opening area between them.
Question: The booster works properly but the signal light is not on
Solution: The cable is too long for the booster, or the connection is not well. Please make sure all the antennas is connected well and tightly. It doesn’t matter too much if the device works well.
If there are any other problems with the product or installation, please contact us.
Thank you!