This product is designed to boost multiple users with maximum power. It is best used in the following applications:
1. Match up with N female 4G 3G PCS DCS CDMA GSM signal repeater
2. Wireless Communications and data transmission system Repeater
3. Omni-directional use for indoor
Attention:
1. This is an indoor Omni-directional antenna only. It doesn’t work alone. You need a Cell Phone Signal Booster/Repeater to work with this antenna.
2. This indoor directional antenna is designed together with the cable, to reduce the loss of the signal and it can be installed easily.
Specification:
1.Model No.:SB-CI-1
2.Frequency range:698-2700MHZ
3.Gain:12dbi
4.VSWR: Under 1.5
5.Vertical polarization
6.Omni antenna
7.F/B ratio: less than18dB
8.Polarization: Vertical
9.Max power:100 W
10.Nominal Impedance:50 OHM
11.Connector: N Female
12.Dimension:180x90mm
13.Weight:450 g
14.Rated wind velocity: 60m/s
Package Contents:
1 x Ceiling Indoor Omni-directional Antenna
12 DBi High Power Omni-directional Indoor Antenna for 4G 3G PCS DCS CDMA GSM repeater Cellular Signal booster Amplifier Antenna
Real item Details:
How it works
1. Receives Signal
The powerful antenna reaches out to access a good signal and delivers it to the booster.
2. Boosters Signal
The booster receives the signal, amplifies it, and serves as a relay between your phone and the nearest cell tower.
3. Broadcasts Signal
Your devices get increased cell reception, and calls and data are fed through the booster back to the network.
how to install
Step 1:
Find a position where you could receive great signal, mostly a higher position, like a rooftop. Install outdoor antenna at it and make it toward the base station.
Note: the outdoor antenna shall receive good signal, otherwise the repeater could not work.
Step 2:
Connect outdoor antenna to booster at BTS connector with the cable.
Step 3:
Connect indoor antenna to booster at MS connector. And it would be better to install it at a height of 2 meters.
Note: The two antennas shall be totally separated by a brick wall with a distance of at least 10 meters. Otherwise, the signal would intervene to each other, showing full of signal on display, but the booster doesn’t work properly.
Step4:
Plug in power supply and done!